About riding

Turning

Turning can be dangerous because it usually means you have to cross the path of other vehicles and must give way to vehicles not turning.

How to turn

To legally and safely make a left or right turn:

  • do a thorough check for other vehicles - in front, behind and to the sides
  • remember to check over your shoulder for your blind spots (the areas of road to the sides of your motorcycle that you can't see in your mirrors)
  • watch for pedestrians
  • signal for at least three seconds
  • turn when safe.

Be prepared to stop, even if the other road user should give way to you.

Important

When turning or changing lanes, remember to always check your blind spots.

Turning from a driveway

If you are riding out of a driveway:

  • slow down to a complete stop at the end of the driveway
  • check the road and footpath for pedestrians, vehicles and other hazards
  • give way to:
    • anyone using the footpath
    • cyclists using a cycle path or cycle lane
    • vehicles on the road, including any vehicle turning right into the driveway.

Making a left turn

If you are turning left into another street or driveway:

  • check your mirrors and your blind spot
  • signal for at least three seconds
  • keep left before and throughout the turn
  • slow down before you turn
  • give way.
Left turn

Left turn


Important

When you are turning left, keep left before and throughout the turn.

If you are turning right, move to left of the centre line or where it would be, and move to a similar position on the road you are turning into.

Making a right turn on a road with no marked lanes

In this situation:

  • check your mirrors and look over your right shoulder to check your blind spot
  • signal for at least three seconds
  • move close to the centre of the road
  • slow down before you turn
  • give way
  • move to a similar place left of the centre of the road.
Right turn on an unlaned road

Right turn on an unlaned road

Making a right turn on a road with a centre line

In this situation:

  • check your mirrors and look over your right shoulder to check your blind spot
  • signal for at least three seconds
  • move towards the centre line
  • slow down before you turn
  • give way
  • turn right, staying close to the centre line.
Right turn on a road with a centre line

Right turn on a road with a centre line

Making a right turn from the left-hand side of the road

If there are other vehicles moving fast or following too closely, or if the road is narrow, it may be best to wait on the left-hand side of the road to make the turn, rather than stopping in the middle of the road and holding up traffic.

In this situation:

  • check your mirror
  • signal left for at least three seconds
  • move across to the left-hand side of the road
  • signal right for at least three seconds before you turn
  • check behind you - this can be difficult on a motorcycle
  • remember to do a head check before you move.

If a vehicle in front of you has also stopped to turn right, it's best to wait behind them and then use the same position to turn from.

Take extra care on roads where the traffic is moving quickly.

Turning right from the left-hand side of the road Turning right from the left-hand side of the road

Turning right from the left-hand side of the road

Making a right turn from a right-turn bay

A right-turn bay is an area where vehicles that are turning right can wait until it is safe to turn, without holding up vehicles going straight through.

You can't use the right-turn bay to overtake a vehicle travelling straight ahead.

As you approach the right-turn bay, the road will be painted with a white triangle with diagonal lines inside it, followed by one or more right-turn arrows.

You can only ride over the white diagonal lines if you are turning right.

Right-turn bay

Right-turn bay

Turning on or off a road with a flush median

A flush median is a strip in the centre of the road that is marked with white diagonal lines within parallel lines. It provides a place for vehicles that are turning right, or vehicles that have turned right onto the road from a side road or driveway.

You can only drive onto the flush median to:

  • wait to move into a gap in the traffic flow after you have turned right (motorcycle A in the diagram below)
  • slow down and wait before turning right (motorcycle B in the diagram below).
Using a flush median

Using a flush median


Important

When using a flush median, watch out for pedestrians who might be waiting on the flush median to cross the road.

Making a U-turn

You are normally allowed to make U-turns, as long as the road is clear in both directions and it is safe to do so. Make sure you have enough room to complete the turn and don't create a hazard for oncoming vehicles.

Position your motorcycle so that you can see. For more information see Safe riding tips.

You aren't allowed to make U-turns on a motorway or if a No U-turn sign is displayed.

Making a turn over a no-passing line

You can cross over the solid yellow no-passing line (if it is safe to do so) when making a turn to enter a driveway or side road.

However, bear in mind that no-passing lines are often marked where visibility is limited, so special care is required. It may be safer to turn further along the road, where visibility is better. For more information about no-passing lines, see Passing.

< previous | next >

Last updated: 7 November 2012