Resources

This Q05 specification has been developed to set out the standard processes required by Waka Kotahi so that assurance can be provided that bitumen of acceptable quality is imported into New Zealand and applied to road pavement surfacings.

This P47 specification covers the minimum environmental, social and cultural management requirements for state highway improvement projects (capital works).

This specification and guidance notes set out the performance requirements for: single coat reseals using sealing chip with an average dimension greater than 5.5mm; multilayer seals using sealing chips in the range of grade 2 to grade 6, as defined i…

This test procedure covers the determination of the rebound deflection of a pavement under a standard wheel load and tyre pressure, with or without temperature measurements.

This specification and guidance notes shall apply to the construction of unbound granular pavement layers.

This standard covers the construction of the concrete weigh pit and fabrication and assembly of the swing arm barrier.

Q/1 Chipsealing specification covers the quality assurance requirements for contracts which include surfacings work incorporating chipsealing.

This specification sets out requirements for edge marker posts (EMPs) as used in the delineation of state highways in accordance with the Traffic Control Devices Manual, Parts 4 and 5.

This specification and guidence notes set out the requirements for repair of edge break in flexible pavements.

This specification and guidance notes cover the construction of earthworks including the clearing and removal of all obstacles within the limits of the earthworks; the excavation of all cuts, including excavation below the final subgrade surface; the…