Displaying 11 - 20 results of 20 for ""
Published: May 2013
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road controlling authorities
This technical memorandum provides advice on the recommended practice for the mitigation of hazards associated with tubular handrails commonly installed for pedestrian/cyclist protection adjacent to roadways and on structures.
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for using low strength concrete around guardrail posts that are installed in hard surfaces such as concrete footpaths.
Published: November 2014
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This technical memorandum provides advice on the recommended practice for the design and installation of transitions between wire rope safety barriers (WRSB) and semi-rigid and rigid barrier systems. The barrier configurations in the memo are generic…
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for the nesting of non-proprietary semi-rigid barrier systems (W-Beam and Thrie-Beam).
Published: November 2012
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road controlling authorities
To advise of the compliance testing requirements for road safety hardware systems.
Published: November 2012
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise of the preferred method of selecting road safety barrier containment (test) level, calculating the length of need (LON) appropriate to that test level and highlighting circumstances under which the LON may be reduced.
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the required practice for installation of slip base sign fixings to ensure safe operation and compliance with NZ Transport Agency P24 specification and RMSA Compliance standard for traffic signs (2008).
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for the lapping of semi-rigid barrier systems (W-beam and thrie-beam).
Published: May 2013
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road controlling authorities
This technical memorandum details advises on the status of bridge W-beam guardrail, its phase-out and accepted (restricted) future use.
Published: September 2015
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
The Transport Agency temporary concrete road safety barrier design (TCB-1) is a metricated variant of the Oregon State Department of Transport (ORDoT) F-shape “Precast Concrete Barrier Pin and Loop Assembly” (RD500).