Back to Resources

Heavy combination vehicle stability and dynamics

An introduction programme for drivers of heavy motor vehicles

Heavy combination vehicle stability and dynamics: an introduction programme for drivers of heavy motor vehicles

3.   Rating different types of combination vehicles

There are two common types of combination vehicle in use on New Zealand roads: truck and trailer; and semi-trailer including ‘B’ trains. A third type common some years ago was the ‘A’ train, but many of these had an inherent stability problem, which has resulted in them being progressively withdrawn from service.

The images below show typical examples of common types of heavy vehicle combinations that can be found in New Zealand, together with their relevant maximum dimensions.

Truck and trailer unit

Truck and trailer unit

Semi-trailer

Semi-trailer

‘B’ train (two semi-trailers)

B train

‘A’ train (one semi-trailer with a full trailer behind)

A train

On a stability rating chart, and taking all relevant factors into consideration, the above combination vehicles can be rated against each other as follows:

StabilityRatingCombination
Most stable 1 Prime mover and semi-trailer
2 ‘B’ train
3 Truck and full trailer
Least stable 4 ‘A’ train

Notwithstanding the above, each type of combination has some inherent characteristics that drivers need to be aware of when they are operating a vehicle of the particular type.

Vehicle typeInherent characteristics
‘A’ train Driver generally receives no roll over feedback.
Susceptible to trailer yaw.
Rear trailer can roll over completely independent of semi-trailer.
Because of the large number of pivot points, this type of combination is susceptible to rearward amplification.
Can be difficult to reverse.
Prime mover and semi-trailer Due to the manner in which the trailer is coupled to the prime mover, in the event of a roll over the complete combination will roll.
Not susceptible to yaw except in extreme situations.
Very susceptible to the effects of low-speed off-tracking.
Relatively easy to reverse.
‘B’ train Due to the manner in which the trailer is coupled to the prime mover, in the event of a roll over the complete combination will roll.
Not susceptible to yaw except in extreme situations.
Very susceptible to the effects of low speed off-tracking particularly when manoeuvring.
Relatively easy to reverse.
Has a large turning circle.
Rigid truck and full trailer Driver generally receives no roll over feedback.
Susceptible to trailer yaw.
Rear trailer can roll over completely independent of towing vehicle.
Good turning circle.
Can be difficult to reverse.
Loading must be spilt between towing vehicle and trailer to ensure adequate braking and traction.