Resources

This specification sets out requirements for edge marker posts (EMPs) as used in the delineation of state highways in accordance with the Traffic Control Devices Manual, Parts 4 and 5.

This specification and guidence notes set out the requirements for repair of edge break in flexible pavements.

This specification and guidance notes cover the construction of earthworks including the clearing and removal of all obstacles within the limits of the earthworks; the excavation of all cuts, including excavation below the final subgrade surface; the…

This specification sets out the requirements for repairs to the pavement structure in flexible pavements, where a digout is required.

The M10 dense graded asphalt specification (version 6) and notes (version 4) cover dense graded asphaltic concrete for roads and related applications.

This specification and guidance notes set out the performance requirements for: single coat reseals using sealing chip with an average dimension greater than 5.5mm; multilayer seals using sealing chips in the range of grade 2 to grade 6, as defined i…

This test procedure covers the determination of the rebound deflection of a pavement under a standard wheel load and tyre pressure, with or without temperature measurements.

This specification and guidance notes set out requirements for basecourse aggregate for use on state highways and other heavily trafficked roadways.

This specification and guidance notes apply only to audio tactile profiled (ATP) road markings.

This specification and accompanying notes describe the procedure by which the contractor shall obtain approval for the nominated adhesion agent and dosage rate with each source of sealing chips that is intended for use on sealing work, except where e…